PSA: my miter saw's blade guard stuck open and I got lucky, check yours
Was cutting baseboard in my garage in Reno last Thursday and noticed the guard on my old miter saw wasn't dropping back down after a cut. I pushed through two more pieces like an idiot before my neighbor looked over and said "man, that guard's not moving." Turns out a little chunk of sawdust had jammed the spring mechanism, and it took me about 20 minutes with a pick and some compressed air to free it up. Now I check the guard by hand before every single session, no exceptions. If you run a miter saw that's older than your car, go look at the guard right now, is it snapping back smooth or dragging?