29
The trick with G41/G42 cutter comp on older Haas mills
I spent 3 hours last Friday fighting with tool paths on our 1998 VF-2, getting gouges every time I tried to use cutter compensation on an inside corner. Turns out I needed to activate the comp at least 0.1 inches before the actual contour start, not right on the geometry point. Anyone else run into weird lead-in distance issues with older controls?
2 comments
Log in to join the discussion
Log In2 Comments
oliviapatel1d ago
0.1 inches sounds crazy early... that's way more than I've ever needed on any machine I've run. My 2001 VF-3 will start gouging if I give it too much lead in. Guess the older ones really are picky about it.
6