CAM backplot caught a bad move before my 3rd setup this week

Running a batch of 316 stainless parts in Tulsa and kept getting a weird gouge on the chamfer, only on one corner. My post processor was fine but I noticed the backplot in Fusion showed the toolpath clipping the edge by 0.012 when I zoomed in on the lead-in. Changed the entry radius from 0.06 to 0.09 and it cleared up. Has anyone else had backplot save them from a scrapped part that looked fine at normal zoom?

0 comments

0 Comments

No comments yet

Be the first to share your thoughts on this discussion.