Serious question, how long did it take you to figure out why my miter saw kept cutting 1/16 inch short on every pass? | Carpenters - The Community Guide
Serious question, how long did it take you to figure out why my miter saw kept cutting 1/16 inch short on every pass?
Spent about 3 hours on a trim job in Gary last weekend chasing this. Checked the blade, checked my marks, even bought a new square. Turned out the detent plate on my old Dewalt had a burr and the saw was creeping a hair past 0 every time I locked it down. Filed it smooth and it cut dead on. What small thing ate half your Saturday like that?
Burr on the detent plate is a sneaky one because the saw still feels like it locks, so you trust the stop without ever checking it with a square. Cheap way to catch it next time: cut a scrap, flip it end for end, and push the two cut faces together against a straight edge. Any gap shows double the error, so a 1/16 short pass shows up as an 1/8 gap fast. Saves you from tearing apart the blade and fence when the real problem is a tiny burr nobody looks at.