Why does nobody talk about sewing stations drifting after a year of use?
Three years back I built a sewing frame out of oak in my garage in Buffalo, and last month I checked it against my old marks and two stations had shifted almost an eighth inch. Half of me says wood moves and you just recheck it, the other half says a frame that cost me $90 in lumber should hold better than that. Where do you all land, do you true up your frame every year or just leave it?
Oak in a garage in Buffalo is a rough combo, that humidity swing from summer to winter is no joke. When you built it, did you seal the end grain on those station bars or leave them raw? That is usually where the drift sneaks in, the ends suck up moisture faster than the faces and the whole piece curls a bit. Also, are the stations pinned or just clamped in place, because a pin hole gives you a fixed point to check against while a clamp can creep without you noticing. Losing an eighth on a $90 frame kinda sounds like the wood doing its thing more than a build mistake, but I would want to know if both shifted the same direction or opposite ways.