Tried a zone-by-zone keypad walk on my first panel swap and it beat the full bench test by a mile
I swapped my first full panel alone in a shop in Boise on Saturday, an 8 zone board in a small warehouse office. I used to bench test everything in the van before hauling it inside, but this time I wired it, then walked each zone with the keypad in hand and opened every door myself. It took maybe 25 minutes and I found two bad reed switches on zone 5 and 7 that the bench test would have missed since they only failed when the door moved. Getting that done before the customer walked in at noon felt good. Does anyone here do a full zone walk every time, or only on older buildings?